Application scope and safety rules of crocodile scrap hydraulic shears
Crocodile scrap hydraulic shearing machine is mainly used in scrap material recycling and processing industries, and small and medium-sized steel plants for various cross-section shapes such as round steel, square steel, channel steel, angle steel, I-beam, steel plate, steel pipe and other scrap metal cold cutting. Compared with the mechanical drive shear, the crocodile scrap hydraulic shear has the advantages of small volume, light weight, small inertia, low noise, smooth movement, safe operation and easy overload protection.
The scissors of crocodile scrap hydraulic shearing machine can be cut and stopped at any position in the working process, and the size of the scissors can be controlled arbitrarily according to the size of the material to be sheared, so as to obtain the highest working efficiency. In addition, the equipment has reasonable technical parameters, wide range of application, low energy consumption, and is widely used in scrap metal recovery processing industry, small and medium-sized steel mills metal shearing, to provide the best burden for refining.
In addition to the advantages of crocodile scrap hydraulic shear itself, it should be designated to operate, others should not be used arbitrarily without training; before starting, should check whether the parts are normal, fasteners are firm. During operation, the human body is not allowed to approach the transmission part and the knife edge of the equipment, and attention should be paid to the safety of the people around to prevent the material from warping and hurting people. Shear should be cut near the knife as far as possible. When cutting short material, no hand-held workpiece should be used for feeding.
When the crocodile scrap hydraulic shearing machine is running, the operator shall not leave the position without authorization. When the work is finished or temporarily leaves the position, the power supply shall be cut off. At the same time, the machine shall not be repaired or touch the moving part with hands or feet. It is forbidden to press materials in the material box with hands or feet. In addition, the lubrication points should be lubricated at least once per shift.