(1) The working parts of the shearing machine are normal , the electrical equipment is in good condition , and the lubrication system is clear ; except for the table and placed on a tool , measuring tools and other debris and marginal waste.
(2) when there is no one single shear operation , should 2--3 coordinates the material , dimensional accuracy and control of materials , etc. , and determines a person unified command.
(3) Under the shear layer thickness , adjusting shears cutting gap. While no shear two different specifications , different materials , a metal plate , not cut corrugated material. The surface of the shear board is smooth , and a narrow sheet cannot be compressed without shearing.
(4) Metal shear belts, flywheels, gears, shafts and other moving parts must be equipped with protective covers. Metal shears
(5) feed port fingers away from the carrier's scissors should be maintained at least 200 is mm , and the clamping device. Placing the protective fence on the scissor trigger can not delay the part of the operator's eyes , but the reduction is invisible. The job is the corner thing , the operator should remove it in time to prevent stab wounds and incisions.
(6) The flywheel , gear , shaft , and moving parts of the metal shearing machine should be protected.
(7) Put the fence to prevent the operator's hand from being put into the scissors set. Prohibit picking up trash at work on the ground , to avoid work injuries.
(8) It is not allowed to cut hardened materials , and it is not allowed to exceed the cutting capacity.
https://www.aupubaler.com/

