How to maintain and service the waste briquetting machine
The maintenance and care of the waste briquetting machine is very important to ensure its normal operation, extend its service life and improve its working efficiency. The following are some maintenance and care methods:
1. Daily maintenance
Cleaning: After each use, all parts of the waste briquetting machine should be cleaned in time, including the machine body, feed port, discharge port, compression chamber, etc. Remove residual waste, dust and oil to keep the equipment clean. Compressed air, brush or damp cloth can be used for cleaning, but be careful to avoid water entering the electrical components.
Check the fasteners: Check the fasteners of the equipment regularly, such as bolts, nuts, screws, etc., to ensure that they are firmly fastened. Loose fasteners may cause unstable operation of the equipment or even damage the equipment. If they are loose, tighten them in time.
Check the hydraulic system: Check the oil level of the hydraulic system to make sure it is within the normal range. If the oil level is too low, add hydraulic oil in time. At the same time, check the pipes, joints and seals of the hydraulic system to make sure they are leak-free. If leaks are found, repair them in time.
Check the electrical system: Check the electrical system's lines, plugs, switches, and contactors to ensure they are firmly connected and free of damage. If any damage is found, replace them in time. At the same time, check whether the electrical system is well grounded to ensure the safety of the operator.
Lubrication: Lubricate key parts of the equipment, such as sliding parts of the compression chamber, bearings, etc. Use appropriate lubricants and lubricate according to the prescribed lubrication cycle to reduce wear and extend the service life of the equipment.
2. Regular maintenance
Replace wearing parts: Regularly check the wearing parts of the Metal Briquetting Machines, such as the seals of the compression chamber, the filter of the hydraulic system, etc., and replace them in time according to the wear and tear. The wear of wearing parts will affect the performance and service life of the equipment, and timely replacement can ensure the normal operation of the equipment.
Check the hydraulic system: Regularly conduct a comprehensive inspection of the hydraulic system, including the oil pump, hydraulic cylinder, control valve, etc. Clean the filter of the hydraulic system and replace the hydraulic oil. Check the pressure and flow of the hydraulic system to ensure that they are within the normal range. If any problems are found, they should be repaired or adjusted in time.
Check the electrical system: Regularly conduct a comprehensive inspection of the electrical system, including the motor, controller, sensor, etc. Check the insulation performance of the motor and clean the heat sink of the motor. Check the program and parameters of the controller to ensure that they are correct. If any problems are found, they should be repaired or adjusted in time.
Calibrate the equipment: Calibrate the waste briquetting machine regularly to ensure the accuracy and performance of the equipment. Calibration includes parameters such as compression pressure and compression size. If the accuracy of the equipment is found to have decreased, it should be calibrated in time.
Operator training: Operators should be trained regularly to improve their operating skills and safety awareness. Operators should be familiar with the equipment's operating procedures and maintenance methods, and operate and maintain the equipment in strict accordance with the regulations.
The maintenance and care of the Waste Plastic Briquette Machine must be carried out regularly to ensure the normal operation of the equipment, extend its service life and improve work efficiency.
If you want to know more about the maintenance and care of waste briquetting machines, please follow www.aupubaler.com !
