1. String the rope of the scrap iron metal briquetting machine through the active spring tightening device behind the metal briquetting machine, and place it along the packing belt slot, then bundle the packing belt to the puller at the bottom of the packing slot, and rotate the active spring tightening device. 90 degrees, close the bottom door and lock it.
2. Put in the material, when the material is loaded to the height of the platen, close the door tightly and press the "down" button. The equipment is actively running, compacting. (The feeding height of materials other than cardboard can only be slightly higher than the bottom door).
3. The pressure plate moves down and compresses to a large pressure and then automatically returns to the fully open position. When compressing and packing, the pressing plate stops at the preset position of the compressed material.
4. Open the door of the equipment and put the tie rope back through the bottom wire groove and back to the front through the pressure plate wire groove. Tighten the tie rope by hand and knot it. Push the packing rod by hand, push the rod to a fixed position, and clamp it tightly. Press the "Up" button, the return trip of the oil cylinder will automatically turn out the bundled bundle. (When opening the lower door, no one is allowed to stand in front of the door, so as to avoid accidental injury when the door is opened);
5. After the bale is ejected, reset the bale rod to press down. Finally remove the bale, close and lock the door to the next baling cycle task.
