Solution to no pressure of metal briquetting machine

Jan 23, 2023 Leave a message

1. It is important to confirm whether it is caused by external factors. ① First, check the zero line and live line of the motor to determine whether the motor is connected reversely. It can detect the rolling direction. If there is a reverse connection, it is necessary to replace the neutral and live wire connectors. ② If the oil level in the oil tank is too low, the hydraulic oil will be pumped out from the interface when the hydraulic pressure is applied, which will also form a metal pressure block without pressure. ③ The regulating valve will not rise. In this case, just adjust the pressure to the desired value.


2. Suppose a hydraulic valve block has defects, the hydraulic valve will not work normally. If it's the cause, it's troublesome. In this case, it is important to judge whether the hydraulic valve is blocked or not. The hydraulic valve block can be disassembled, cleaned and then installed into the metal briquetting machine. If there is no pressure, there may be a break. The problem can be solved by replacing a new hydraulic valve module.


3. The hydraulic system has severe oil leakage, which can also cause pressure shortage. In case of such a problem, carefully check the main hydraulic pipeline and hydraulic cylinder of the briquetting machine for oil leakage. This phenomenon is handled simply by sealing the sealing ring and cylinder sealing ring.


4. If the pressure gauge fails, the flashing pressure is not the actual pressure of the system. Check by adjusting the system pressure. If there is any problem, it can be solved by replacing the pressure gauge.


5. For the power tension spring, check whether the voltage is stable. Too low voltage and system pressure; It is also necessary to check whether the motor is installed, which can be handled by placing a stabilizer or a motor.


6. The hydraulic system planning is unreasonable. There are too many pipe bends, the oil cylinder consumes oil, and the hydraulic pressure is small. There is no pressure for the briquetting machine, so the manufacturer should be contacted for handling. At present, the metal briquetting machine has entered the market, and the products are sophisticated. The factory can also test the machine for many times. After satisfying the technical requirements, the mall can operate normally. The above six reasons may cause the briquetting machine not to compress. Assuming that your metal briquetting machine also has this situation, you can completely eliminate it according to these 6 points. Mechanical maintenance tips: if defects appear, careful and comprehensive inspection is required. The details of the ingot machine equipment can not be found, and the causes of the shortcomings of the briquetting machine can not be found and solved.

www.aupubaler.com