1. For semi-automatic ones purchased by enterprises, you can use existing clamping materials or recycled materials, very thick bags, and use this type when you do not need to make basic adjustments to the severity of the packaging and the length of the outer belt according to customer requirements. Bag adjustment. If the customer uses pure PP packing straps and they are very thin, then these straps can slightly adjust the strap length to the binding force of the scrap metal strapping machine.
2. If the enterprise uses a fully automatic machine, this kind of machine has high requirements on the quality and various indicators of the packing table. The size of the packing belt is adjusted first depending on the size of the arch, then the pressure of the pressure wheel, and then according to the conveyor belt Adjust the strapping force and transmission time accordingly
3. If the company buys an unmanned one, what needs to be adjusted is the position of its photoelectric switch. Secondly, it can be adjusted according to the adjustment method of the above-mentioned scrap metal baler.
4. Strap width and seam adjustment. Strap width is uneven, or the length of the left and right slots is too narrow when replacing straps with different widths, making it difficult to insert the straps. If the width is too wide, the joints of the straps after the binding machine will not overlap. The typical slot width should be approximately 0.5-1mm larger than the frequency bandwidth.
5. Adjusting the temperature of the ironing head. The temperature of the ironing head has a great influence on the quality of the belt connector. Polypropylene demolding strap joint fixing knob is usually placed in the file position. It can be confirmed whether the temperature of the iron head is appropriate and the surface adhesion of the iron head can be confirmed. If the hot-bonding surface has white marks, the temperature is already high: the hot-bonding surface is wet, the temperature is insufficient.
6. Open the Taiwan panel with the elastic band of the strapping bag, unscrew the hexagonal fixing screw on the top hat a by hand, and tighten or loosen it clockwise. If the joining force is appropriate, tighten the hexagonal set screws.
7. Packing strap length adjustment The length of the strapping strap is determined by the strapping length adjuster on the front panel. The strap is too short and it is easy to tie your hands. At this time, the baler can be grasped by hand, and the belt can be pulled out in the direction of belt feeding. The length of the strapping strap must be readjusted, but the length of the delivery strap needs to be readjusted to ensure the normal strapping of the next lane. The strap of the strapping machine is too long to be easily positioned. The scrap metal strapping machine and the pulled-out tape are entangled together, and the strap does not fit well or breaks easily.
https://www.aupubaler.com/