Reasons for the large noise of the plunger pump of the metal baler on site

Jan 18, 2022 Leave a message

(1) Check whether the oil inlet pipe of the pump sucks in air, causing the pump to have loud noise, vibration, and pressure fluctuations. The editor recommends to prevent the pump from insufficient oil suction and air suction due to poor sealing and high oil suction pipe resistance (such as excessive bending, excessive pipe length).


(2) Check whether the coaxiality between the pump and the engine (or motor) is out of tolerance: the pump and the engine are installed differently, so that the pump and the drive shaft are subjected to radial force, and the coaxiality should be readjusted.


(3) Check whether the movement of the servo piston and the variable piston is flexible, occasional or frequent pressure fluctuations: if it is accidental pulsation, it is mostly caused by oil and dirt blocking the piston. The dirt can be washed away and it can be restored to normal. At this time, it can be cleaned and Change the grease. If it is frequent pulsation, it may be a strain on the accessory or do not use force. At this time, the parts should be removed for research and development or replacement.


(4) For the variable pump, it may be because the deflection angle of the variable swash plate is too small, the flow is too small, and the internal leakage is relatively increased. Ruichang Machinery reminded that continuous oil supply is not possible, and pressure pulsation caused by flow pulsation. The editor reminds that in this case, the deflection angle of the swash plate can be appropriately increased to eliminate internal leakage.


(5) The loose shoe mentioned above, that is, the loosening of the plunger ball head and the sliding shoe produces noise, vibration and pressure fluctuations, which can be riveted appropriately.


(6) Replace the hemisphere sleeve when it is worn or damaged.


(7) After the oil distribution pan is repaired by flat grinding, the triangular eyebrow grooves become shorter, resulting in trapped oil, resulting in greater noise and pressure fluctuations. Assorted triangular files can be used to properly lengthen the triangular eyebrow grooves.

https://www.aupubaler.com/