Packaging in the horizontal metal briquetting machine

Sep 11, 2022 Leave a message

The order of packaging in the horizontal metal briquetting machine


The working process of the horizontal metal briquetting machine is roughly as follows: the plastic bags on the belt reel are fed into the belt storage box by the belt pre-feeding equipment, and then fed into the track by the belt feeding wheel, and then start the baling action, each baling action is Automatically pack according to a certain order. Mainly in the following order.


The first is to come back and pack:

Lift the chuck in the horizontal metal briquetting machine to clamp the plastic tape head, the feed pulley turns around and retract the plastic tape, put the excess plastic tape back into the tape storage box and tighten the bundled items. The operator then grabs the plastic tape and further tightens the package to a certain extent. Next is the tape cutting and gluing:


The guide plate is withdrawn from the middle of the two layers of plastic belts, and the ironing head is inserted between the two layers of plastic belts at the same time, and then the two chucks rise to clamp the wire at the other end of the plastic belt, the cutter cuts the plastic belt, and pushes the wire to touch the ironing head. Heating and melting (surface), then the perm head is quickly withdrawn, the knife continues to rise, and the two layers of plastic tapes with melted surfaces are pressed on the carrier plate, and then cooled and solidified, and the two layers of tapes are bonded. The strapped plastic belt loops are pulled out by the support plate, and each chuck is reset to the horizontal metal briquetting machine to complete the strapping.


Finally, the belt feeding pulley rotates forward to send the plastic belt from the storage box into the track to prepare for the next bundling, and finally the metal block of the horizontal metal briquetting machine is unloaded.


The above is the sequential packaging process of the horizontal metal briquetting machine. When the machine is in the interlock state, after the belt feeding is completed, it will directly enter the belt unwinding and tensioning procedures, and follow the above procedures one after another.

www.aupubaler.com