Working principle of the mainframe and hydraulic system of the waste car baler
The car is a kind of waste packing machine is mainly used for a variety of thin plastic black and non-ferrous metal waste material of cold block packing, to form a close rectangular bag piece, which is convenient for storage and transportation of the scrap metal processing equipment, widely used in steel, nonferrous metal smelting plant, refinery etc..
Scrap automobile packing machine is mainly composed of host computer, electrical system and hydraulic system, which includes a host body, master cylinder, cylinder, cylinder, cylinder cover over packet and other parts will be packaged into the material in the material box, operating the reversing valve handle, the door cover is closed and lock the door cover lock. Do not go up, the primary preloading, then proceed the secondary compression pressure cylinder.
Waste auto packing machine stroke in place, main pressure cylinder forward final compression, master cylinder system pressure keeps the pressure after 3~5 seconds, the main and side pressure cylinder return, pull out the lock and open the door cover, turn bag bag piece and the return cylinder work out, this time to complete a cycle of work.
The hydraulic system of the waste car baler is made up of oil pump, fuel tank, hydraulic station, pipeline and so on. When the valve handles are in the middle position, the high-pressure oil is turned back into the fuel tank through the reversing valve, and the system is operated at no load. The main pressure cylinder handle is pulled to the front, then the main pressure cylinder advances and the back position is pulled, then the main pressure cylinder is back. The side pressure cylinder valve handle is pulled to the front side pressure cylinder, the handle is pulled back to the back position, then the side pressure cylinder is back, the roll cylinder is turned up or reset.
If there is no significant vibration in the waste car baler, there is no special requirement for the foundation. The user can set the machine in the indoor according to the specific conditions and pour the ordinary concrete floor. Then the main engine is dropped and its level is preliminarily adjusted; the electric box is installed on the tank. In addition, users are required to prepare their own 60A automatic air switch and introduce power into the electric box.